Blog

Spire Integrated Solutions, the premier manufacturer of steam sterilizers and washing equipment for the Vivarium marketplace, headquartered in Orlando, Florida, introduced the company's next-generatio

Take a look at these points when troubleshooting Process Settings on a PRIMUS sterilizer.The gasket pressure air regulator was set at 85 PSIG instead of the required 30 PSIG.Found the chamber drain bl

Periodically, PRIMUS experiences repetitive field failures of steam-to-jacket valves and steam-to-chamber valves immediately following the start-up of a new steam sterilizer using in-house steam.Acute

The PRIMUS Pri-Matic® control system’s first three cycle recipes (i.e., the cycle parameter data) are programmed during the PRIMUS Factory Acceptance Test (FAT). There are numerous parameters which ca

Take a look at these points when troubleshooting the calibration on a PRIMUS sterilizer.The chamber was incorrectly calibrated:Low setpoint 60.9 – should have been 90High setpoint 60.9 - should have b

Take a look at these points when troubleshooting controls & electrical issues on a PRIMUS sterilizer.The battery in the UPS was bad and had not been replaced.The Opto 22 rack is loose. The Opto 22 rac